Difference between revisions of "GigaDevice GD32F310F-START"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32F310F-START evaluation board.<br> 450px == Preparin...") |
(→Example Project) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 20: | Line 20: | ||
*Power the board via CN100. |
*Power the board via CN100. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:GigaDevice_GD32F310F-START_GD32F310F8P6_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310F-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
− | * |
+ | *Embedded Studio: V7.12a |
+ | *Hardware: GigaDevice GD32F310F-START |
||
− | *Embedded Studio: V7.20 |
||
+ | *Link: [[File:GigaDevice_GD32F310F8P6_TestProject_ES_7V12a.zip]] |
||
− | *Hardware: GigaDevice GD32F303B-START |
||
− | *Link: [[File:GigaDevice_GD32F303B-START_GD32F303CB_TestProject_ES_7V20.zip]] |
Latest revision as of 16:17, 27 February 2024
This article describes specifics for the GigaDevice GD32F310F-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP3 | 1 | +V |
GND | JP3 | 4 | G |
TMS/SWDIO | JP3 | 2 | IO |
TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F310F-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32F310F-START
- Link: File:GigaDevice GD32F310F8P6 TestProject ES 7V12a.zip