Difference between revisions of "GigaDevice GD32F310F-START"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32F310F-START evaluation board.<br> 450px == Preparin...")
 
(→‎Preparing for J-Link)
Line 20: Line 20:
 
*Power the board via CN100.
  
*Power the board via CN100.
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
−
[[File:GigaDevice_GD23F303B-START_GD32F303CB_connect.png|400px]]
 +
[[File:GigaDevice_GD32F310F-START_GD32F310F8P6_connect.png|400px]]
   
 
== Example Project==
  
== Example Project==

Revision as of 15:53, 27 February 2024

This article describes specifics for the GigaDevice GD32F310F-START evaluation board.
GigaDevice GD32F310F-START GD32F310FCB board.jpg

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref JP3 1 +V
GND JP3 4 G
TMS/SWDIO JP3 2 IO
TCK/SWCLK JP3 3 CK
  • Power the board via CN100.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GigaDevice GD32F310F-START GD32F310F8P6 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=GigaDevice_GD32F310F-START&oldid=18040"