Difference between revisions of "IMX6ULL-EVK"
(→Enable debugging via JTAG) |
|||
Line 4: | Line 4: | ||
*R1431-1434 |
*R1431-1434 |
||
− | Note: This changes are only valid for revision one boards. You can recognize them by flipping the board around and the two stickers on the back must read this: |
+ | '''Note:''' This changes are only valid for revision one boards. You can recognize them by flipping the board around and the two stickers on the back must read this: |
700-28616 REV A1 |
700-28616 REV A1 |
Revision as of 12:07, 14 September 2017
Enable debugging via JTAG
In order to use the enable to pins of the JTAG connector of the IMX6ULL-EVK eval board, the following resistors need to be desoldered:
- R1407
- R1431-1434
Note: This changes are only valid for revision one boards. You can recognize them by flipping the board around and the two stickers on the back must read this:
700-28616 REV A1
SCH-28616 REV C1