Difference between revisions of "IMX6ULL-EVK"
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
==Enable debugging via JTAG== |
==Enable debugging via JTAG== |
||
In order to use the enable to pins of the JTAG connector of the IMX6ULL-EVK eval board, the following resistors need to be desoldered: |
In order to use the enable to pins of the JTAG connector of the IMX6ULL-EVK eval board, the following resistors need to be desoldered: |
||
| Line 4: | Line 5: | ||
*R1431-1434 |
*R1431-1434 |
||
| − | + | {{Note|This changes are only valid for revision one boards. You can recognize them by flipping the board around and the two stickers on the back must read this: |
|
| + | *700-28616 REV A1 |
||
| − | |||
| − | + | *SCH-28616 REV C1 |
|
| + | }} |
||
| − | |||
| − | SCH-28616 REV C1 |
||
Latest revision as of 13:15, 15 May 2024
Enable debugging via JTAG
In order to use the enable to pins of the JTAG connector of the IMX6ULL-EVK eval board, the following resistors need to be desoldered:
- R1407
- R1431-1434
Note:
This changes are only valid for revision one boards. You can recognize them by flipping the board around and the two stickers on the back must read this:
- 700-28616 REV A1
- SCH-28616 REV C1
