Difference between revisions of "Infineon CY-SD2211"
(→SETUP) |
|||
Line 22: | Line 22: | ||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: Infineon CY-SD2211 |
*Hardware: Infineon CY-SD2211 |
||
− | *Link: [[File: |
+ | *Link: [[File:Infineon_CY-SD2211_Rev07_CYPD7291-68LDXS_TestProject_ES_7V20.zip]] |
Revision as of 10:52, 22 February 2024
This article describes specifics for the Infineon CY-SD211 evaluation board.
Preparing for J-Link
- Connect the J-Link to J18:
- GND on J18.2
- SWDIO on J18.5
- SWCLK on J18.4
- Reset on J18.3
- VTref on TP13
- Power the board via J5.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon CY-SD2211.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94k
- Embedded Studio: V7.20
- Hardware: Infineon CY-SD2211
- Link: File:Infineon CY-SD2211 Rev07 CYPD7291-68LDXS TestProject ES 7V20.zip