Infineon CY-SD2211
Revision as of 13:18, 27 December 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Infineon CY-SD211 evaluation board.<br> 450px == Preparing for J...")
This article describes specifics for the Infineon CY-SD211 evaluation board.
Preparing for J-Link
- Connect the J-Link to J18:
- GND on J18.2
- SWDIO on J18.5
- SWCLK on J18.4
- Reset on J18.3
- VTref on TP13
- Power the board via J5.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon CY-SD2211.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94c
- Embedded Studio: V7.20
- Hardware: Infineon CY-SD2211
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip