Difference between revisions of "LPCXpresso4337 V3"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "==Enable debugging via SWD== In order to use the J-Link to debug the LPC4337 on the board, the following changes needs to be done: *Remove JP1 *Manually connect Pin1 of the SW...")
 
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
==Enable debugging via SWD==
+
==Enable Debugging via SWD==
 
In order to use the J-Link to debug the LPC4337 on the board, the following changes needs to be done:
 
In order to use the J-Link to debug the LPC4337 on the board, the following changes needs to be done:
 
*Remove JP1
 
*Remove JP1
 
*Manually connect Pin1 of the SWD debug connector (P1) to 3.3V (VTref)
 
*Manually connect Pin1 of the SWD debug connector (P1) to 3.3V (VTref)
  +
*Connect the J-Link to the target using the SWD debug connector (P1)

Latest revision as of 19:06, 10 February 2017

Enable Debugging via SWD

In order to use the J-Link to debug the LPC4337 on the board, the following changes needs to be done:

  • Remove JP1
  • Manually connect Pin1 of the SWD debug connector (P1) to 3.3V (VTref)
  • Connect the J-Link to the target using the SWD debug connector (P1)