Microchip CuriosityUltra PIC32CZCA80

From SEGGER Wiki
Revision as of 16:49, 13 December 2023 by Artjom.Kister (talk | contribs) (Created page with "This article describes specifics for the Microchip Curiosity Ultra PIC32CZCA80 evaluation board. It can be used to test & verify PIC32CZCA80 device support. __TOC__ File:Mic...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Microchip Curiosity Ultra PIC32CZCA80 evaluation board. It can be used to test & verify PIC32CZCA80 device support.

Microchip PIC32CZCA80 board.JPG

Minimum requirements

  • J-Link software V7.94a or later

Preparing for J-Link

  • Connect the J-Link to CORTEX DEBUG connector (J300).
  • Power the board via Power jack connector (J100).
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Microchip PIC32CZCA80 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip Curiosity Ultra PIC32CZCA80.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Microchip_CuriosityUltra_PIC32CZCA80&oldid=17269"