MindMotion MB-101-Mini-G5333-OB

From SEGGER Wiki
Revision as of 13:52, 7 September 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Mindmotion Mini-G5333-OB evaluation board. 450px == Minimum r...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Mindmotion Mini-G5333-OB evaluation board.

450px

Minimum requirements

  • J-Link software V7.92e or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (P2)
  • Power the board via USB-C (P4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MindMotion MB-101-Mini-G5333 MM32G5333D4QV connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-G5333-OB.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=MindMotion_MB-101-Mini-G5333-OB&oldid=16235"