Difference between revisions of "MindMotion Mini-SPIN0280"
(→SETUP) |
|||
Line 15: | Line 15: | ||
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.86f |
*J-Link software: V7.86f |
||
− | *Embedded Studio: |
+ | *Embedded Studio: V7.20 |
*Hardware: MindMotion Mini-SPIN0280 |
*Hardware: MindMotion Mini-SPIN0280 |
||
− | *Link: [[File:MindMotion_Mini- |
+ | *Link: [[File:MindMotion_Mini-SPIN0280_MM32SPIN0280D6PV_TestProject_ES_7V20.zip]] |
Revision as of 12:06, 16 April 2024
This article describes specifics for the MindMotion Mini-SPIN0280 evaluation board.
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-SPIN0280 .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86f
- Embedded Studio: V7.20
- Hardware: MindMotion Mini-SPIN0280
- Link: File:MindMotion Mini-SPIN0280 MM32SPIN0280D6PV TestProject ES 7V20.zip