Difference between revisions of "MindMotion Mini-SPIN0280"
(Created page with "__TOC__ This article describes specifics for the MindMotion Mini-SPIN0280 evaluation board.<br> '''[PICTURE OF BOARD]''' File:MindMotion_Mini-SPIN0280_MM32SPIN0280C6PV_boar...") |
|||
| Line 2: | Line 2: | ||
This article describes specifics for the MindMotion Mini-SPIN0280 evaluation board.<br> |
This article describes specifics for the MindMotion Mini-SPIN0280 evaluation board.<br> |
||
| + | [[File:MindMotion_Mini-SPIN0280_MM32SPIN0280D6PV_board.jpg|450px]] |
||
| − | '''[PICTURE OF BOARD]''' |
||
| − | [[File:MindMotion_Mini-SPIN0280_MM32SPIN0280C6PV_board.jpg|450px]] |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Revision as of 11:57, 16 April 2024
This article describes specifics for the MindMotion Mini-SPIN0280 evaluation board.
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-SPIN0280 .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86f
- Embedded Studio: V6.34
- Hardware: MindMotion Mini-SPIN0280
- Link: File:MindMotion Mini-SPIN0280 MM32SPIN0280C6PV TestProject ES 6V34.zip
