Difference between revisions of "Mindmotion-MB-025"
(Created page with "__TOC__ This article describes specifics for the Mindmotion MB-025 evaluation board. 450px == Minimum requirements == * J-Link software V7.82d...") |
|||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:35, 8 May 2024
This article describes specifics for the Mindmotion MB-025 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link #########################################
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-025 ##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-025
- Link: File:MM xxx TestProject ES V634.zip
