Difference between revisions of "Mindmotion-MM32 LQFP48"
Line 16: | Line 16: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MM32 LQFP48 |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MM32 LQFP48 MM32F0144C6P.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.82e |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion MM32 LQFP48 |
*Hardware: Mindmotion MM32 LQFP48 |
Revision as of 14:50, 9 December 2022
This article describes specifics for the Mindmotion MM32 LQFP48 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link to J3
- Power the board via USB (J2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MM32 LQFP48 MM32F0144C6P.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.34
- Hardware: Mindmotion MM32 LQFP48
- Link: File:MM xxx TestProject ES V634.zip