Difference between revisions of "Mindmotion-MM32 LQFP48"
(→Minimum requirements) |
|||
Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:MM_MM32F0144C6P_EVAL_MM32LQFP48_Connect.png|400px]] |
== Example Project== |
== Example Project== |
Revision as of 14:28, 9 December 2022
This article describes specifics for the Mindmotion MM32 LQFP48 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link to J3
- Power the board via USB (J2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MM32 LQFP48 ##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MM32 LQFP48
- Link: File:MM xxx TestProject ES V634.zip