Difference between revisions of "Mindmotion BIRD-F3F5 MM32F5287"
(2 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the |
+ | This article describes specifics for the MindMotion BIRD-F3/F5 MM32F5287L8PV evaluation board. |
[[File:MindMotion_BIRD-F3F5_MM32F5287_Board.jpg|450px]] |
[[File:MindMotion_BIRD-F3F5_MM32F5287_Board.jpg|450px]] |
||
Line 13: | Line 14: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:MindMotion_BIRDF3F5_MM32F5287L8PV_connect.png|400px]] |
== Example Project== |
== Example Project== |
Latest revision as of 15:34, 8 May 2024
This article describes specifics for the MindMotion BIRD-F3/F5 MM32F5287L8PV evaluation board.
Minimum requirements
- J-Link software V7.86i or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J1)
- Power the board via USB-C (J5)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion BIRD-F3/F5 MM32F5287.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86i
- Embedded Studio: V6.34
- Hardware: MindMotion BIRD-F3/F5 MM32F5287
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip