Mindmotion Mini-F5233-MM32F5233D7P
Revision as of 13:39, 7 September 2023 by Torben.scharping (talk | contribs) (→Preparing for J-Link)
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
Minimum requirements
- J-Link software V7.92d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN3)
- Power the board via USB-C (CN7)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-F5233 MM32F5233D7P.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92d
- Embedded Studio: V7.30
- Hardware: MindMotion Mini-F5233 MM32F5233D7P
- Link: File:MindMotion MM32F5233 TestProject ES 7V20.zip