Difference between revisions of "Mindmotion PLUS5270 MM32F5270"
| Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File: |
+ | [[File:MM_PLUS5270_MM32F5270_Connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 09:44, 4 November 2022
This article describes specifics for the Mindmotion PLUS5270 MM32F5270 evaluation board.
Minimum requirements
- J-Link software V6.83 or later
Preparing for J-Link
- Connect the J-Link to the SWD header (P15)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.83
- Embedded Studio: V6.34
- Hardware: Mindmotion PLUS5270 MM32F5270
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip
