Difference between revisions of "NUCLEO-F103RB"
(Created page with "__TOC__ This article describes specifics for the ST NUCLEO-F103RB evaluation board.<br> 400px == Preparing for J-Link == *Power the board via...") |
|||
| Line 12: | Line 12: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:NUCLEO-F103RB_con.PNG|400px]] |
[[File:NUCLEO-F103RB_con.PNG|400px]] |
||
| + | *Note select device: "STMF103RB". |
||
== Example Project== |
== Example Project== |
||
Revision as of 14:35, 4 August 2023
This article describes specifics for the ST NUCLEO-F103RB evaluation board.
Preparing for J-Link
- Power the board via CN1 (Mini)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STMF103RB".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F103RB.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F103RB
- Link: File:NUCLEO-F103RB Projekt.zip
