Difference between revisions of "NUCLEO-F207ZG"
| Line 7: | Line 7: | ||
*Power the board via Mini USB (CN1) |
*Power the board via Mini USB (CN1) |
||
| + | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:STMNUCLEO-F207ZG_con.PNG|400px]] |
[[File:STMNUCLEO-F207ZG_con.PNG|400px]] |
||
Revision as of 16:01, 22 August 2023
This article describes specifics for the ST STM3210C-EVAL evaluation board.
Preparing for J-Link
- Power the board via Mini USB (CN1)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32F107VC".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F207ZG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F207ZG
- Link: File:NUCLEO-F207ZG Projekt.zip
