NXP MCIMX7ULP-EVK

From SEGGER Wiki
Revision as of 17:28, 8 March 2024 by Matthias (talk | contribs) (Created page with "__TOC__ This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.
NXP MCIMX7ULP-EVK.jpg

Preparing for J-Link

  • Connect the J-Link to the 20 pin JTAG connector (J6)
  • Power the board via 5V power jack (P1)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP MCIMX7ULP-EVK CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCIMX7ULP-EVK.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_MCIMX7ULP-EVK&oldid=18220"