Difference between revisions of "NXP MCIMX7ULP-EVK"
(Created page with "__TOC__ This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link...") |
(→Example Project) |
||
Line 11: | Line 11: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCIMX7ULP-EVK.<br>It is a simple Hello World sample linked into the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Cortex-M4 core of NXP MCIMX7ULP-EVK.<br>It is a simple Hello World sample linked into the external SPI flash @0x04000000.<br> |
====SETUP==== |
====SETUP==== |
||
*Embedded Studio: V8.10b |
*Embedded Studio: V8.10b |
Revision as of 17:33, 8 March 2024
This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to the 20 pin JTAG connector (J6)
- Power the board via 5V power jack (P1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Cortex-M4 core of NXP MCIMX7ULP-EVK.
It is a simple Hello World sample linked into the external SPI flash @0x04000000.
SETUP
- Embedded Studio: V8.10b
- Hardware: NXP MCIMX7ULP-EVK
- Link: File:NXP MCIMX7ULP-EVK TestProject ES V810b.zip