Difference between revisions of "NXP MCIMX8DXL-WEVK"
(Created page with "This article describes specifics for the NXP MCIMX8DXL-WEVK evaluation board. It can be used to test & verify NXP iMX 8 XLite device support for Cortex-M4. __TOC__ File:NXP_...") |
|||
Line 11: | Line 11: | ||
*Connect the onboard USB-UART debug interface to host computer (J19). |
*Connect the onboard USB-UART debug interface to host computer (J19). |
||
*Open a serial interface communication via terminal application(PuTTY). |
*Open a serial interface communication via terminal application(PuTTY). |
||
− | *Power the board via |
+ | *Power the board via Power connector (J1). |
*Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows: |
*Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows: |
||
[[File:NXP_MCIMX8DXL_EVK_boot.png|400px]] |
[[File:NXP_MCIMX8DXL_EVK_boot.png|400px]] |
Latest revision as of 10:31, 5 April 2024
This article describes specifics for the NXP MCIMX8DXL-WEVK evaluation board. It can be used to test & verify NXP iMX 8 XLite device support for Cortex-M4.
Minimum requirements
- J-Link software V7.94 or later
- The board should have a bootloader(U-Boot) image on one of the available boot device
Preparing for J-Link
- Connect the J-Link to JTAG connector (J18).
- Connect the onboard USB-UART debug interface to host computer (J19).
- Open a serial interface communication via terminal application(PuTTY).
- Power the board via Power connector (J1).
- Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCIMX8DXL-WEVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94
- Embedded Studio: V8.10
- Hardware: NXP MCIMX8DXL-WEVK
- Link: File:NXP MCIMX8DXL-EVK M4 TestProject ES 8V10.zip