Difference between revisions of "NXP NHS52Sxx EVK"
(→Example Project) |
|||
| Line 44: | Line 44: | ||
*Embedded Studio: V6.34a |
*Embedded Studio: V6.34a |
||
*Hardware: NXP NHS52Sxx_EVK |
*Hardware: NXP NHS52Sxx_EVK |
||
| − | *Link: [[ |
+ | *Link: [[Media:NXP_NHS52S04_TestProject.zip | NXP_NHS52S04_TestProject.zip]] |
Revision as of 10:14, 10 October 2022
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. It comes with an NXP NHS52S04 MCU mounted.
Contents
Minimum requirements
- J-Link software V7.80 or later.
Preparing for J-Link
The board can be powered via the USB_PWR USB slot.
For jumper configuration see: Jumper configuration.
The J-Link can be connected via the J11 SWD port, e.g. using the SEGGER 9-Pin Cortex-M Adapter.
- Verify the Connection with e.g. J-Link Commander.
The output should look as follows:
Jumper configuration
J-Link support was tested with the following jumper selection (as marked as in the picture above).
| Jumper | Selection |
|---|---|
| J3 | 1-2 (3V) |
| J4 | USB |
| J9 | 1-2 |
| J10 | 1-2 |
| J28 | 1-2 |
| J30 | 1-2 |
| J36 | 1-2 & 3-4 |
| Other | NOT SET |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP NHS52Sxx_EVK. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.80
- Embedded Studio: V6.34a
- Hardware: NXP NHS52Sxx_EVK
- Link: NXP_NHS52S04_TestProject.zip
