Difference between revisions of "NXP NHS52Sxx EVK"
(→Example Project) |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
[[File:NXP_NHS52Sxx_EVK.jpg|450px|thumb|right]] |
[[File:NXP_NHS52Sxx_EVK.jpg|450px|thumb|right]] |
||
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. |
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. |
Latest revision as of 15:33, 8 May 2024
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. It comes with an NXP NHS52S04 MCU mounted.
Contents
Minimum requirements
- J-Link software V7.80 or later.
Preparing for J-Link
The board can be powered via the USB_PWR USB slot.
For jumper configuration see: Jumper configuration.
The J-Link can be connected via the J11 SWD port, e.g. using the SEGGER 9-Pin Cortex-M Adapter.
- Verify the Connection with e.g. J-Link Commander.
The output should look as follows:
Jumper configuration
J-Link support was tested with the following jumper selection (as marked as in the picture above).
Jumper | Selection |
---|---|
J3 | 1-2 (3V) |
J4 | USB |
J9 | 1-2 |
J10 | 1-2 |
J28 | 1-2 |
J30 | 1-2 |
J36 | 1-2 & 3-4 |
Other | NOT SET |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP NHS52Sxx_EVK. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.80
- Embedded Studio: V6.34a
- Hardware: NXP NHS52Sxx_EVK
- Link: NXP_NHS52S04_TestProject.zip