Difference between revisions of "NXP PNEV7642A"
(Created page with "__TOC__ This article describes specifics for the NXP PNEV7642A evaluation board. It can be used to test & verify PN76 device support with J-Link. File:NXP_PN...") |
(No difference)
|
Revision as of 15:20, 25 November 2022
This article describes specifics for the NXP PNEV7642A evaluation board. It can be used to test & verify PN76 device support with J-Link.
Minimum requirements
- J-Link software V7.65b or later
Preparing for J-Link
- Connect the J-Link to the debug connector (J21)
- Power the board via USB (J5)
Afterwards, the board should look similar to this:
Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP PNEV7642A. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.22
- Hardware: NXP PNEV7642A
- Link: File:NXP PNEV7642A ES V622.zip