Difference between revisions of "NXP S32K144EVB-Q100"
(Created page with "__TOC__ = Connecting an external J-Link = The eval board provides 2 debug connectors: * J12 SDA (Connects to the OpenSDA on the board. Usually not needed by the user. Only ne...") |
(No difference)
|
Revision as of 15:45, 16 November 2020
Connecting an external J-Link
The eval board provides 2 debug connectors:
- J12 SDA (Connects to the OpenSDA on the board. Usually not needed by the user. Only needed to reflash the bootloader of OpenSDA if needed)
- J14 SWD (Connects to the S32K144 device)
J14 SWD can be used to connect an external J-Link to the S32K144 device. A J-Link 9-pin Cortex-M adapter is needed to adapt to J14 SWD.
Connecting via on-board OpenSDA
The eval board provides an on-board debug circuit called OpenSDA. This debug circuit can run a firmware to make it behave like a J-Link. For more info please refer to: SEGGER website - OpenSDA