Difference between revisions of "NXP X-KW45B41Z"
(→Preparing for J-Link) |
(→SETUP) |
||
Line 20: | Line 20: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
+ | TBD |
||
+ | <!-- |
||
*J-Link software: V7.7 |
*J-Link software: V7.7 |
||
*Embedded Studio: V6.11 |
*Embedded Studio: V6.11 |
||
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
||
*Link: [[File:NXP_QN9090_TestProject_ES_V452b.zip]] |
*Link: [[File:NXP_QN9090_TestProject_ES_V452b.zip]] |
||
+ | --> |
Revision as of 17:17, 9 January 2023
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support.
Minimum requirements
- J-Link software V7.7 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Put a Jumper on J22 to activate the debug interface
- Connect the J-Link to the SWD header (J16)
- Power the board via external power supply (J14)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.
SETUP
TBD