Difference between revisions of "NXP X-KW45B41Z"
(2 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 15: | Line 16: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:NXP_X-KW45B41Z_JLinkCommander.PNG|400px]] |
== Example Project== |
== Example Project== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
+ | TBD |
||
+ | <!-- |
||
*J-Link software: V7.7 |
*J-Link software: V7.7 |
||
*Embedded Studio: V6.11 |
*Embedded Studio: V6.11 |
||
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
*Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
||
*Link: [[File:NXP_QN9090_TestProject_ES_V452b.zip]] |
*Link: [[File:NXP_QN9090_TestProject_ES_V452b.zip]] |
||
+ | --> |
Latest revision as of 15:24, 8 May 2024
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support.
Minimum requirements
- J-Link software V7.7 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Put a Jumper on J22 to activate the debug interface
- Connect the J-Link to the SWD header (J16)
- Power the board via external power supply (J14)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.
SETUP
TBD