Difference between revisions of "NXP X-KW45B41Z"
(Created page with "__TOC__ This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP...") |
|||
| Line 3: | Line 3: | ||
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support. |
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support. |
||
| − | [[File: |
+ | [[File:NXP_X-KW45B41Z.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
Revision as of 17:15, 9 January 2023
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support.
Minimum requirements
- J-Link software V7.7 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Put a Jumper on J22 to activate the debug interface
- Connect the J-Link to the SWD header (J16)
- Power the board via external power supply (J14)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.7
- Embedded Studio: V6.11
- Hardware: NXP JN5189-DK006 (QN9090 upgrade board)
- Link: File:NXP QN9090 TestProject ES V452b.zip
