Difference between revisions of "NXP X-KW45B41Z"
(→SETUP) |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:24, 8 May 2024
This article describes specifics for the NXP KW45B41Z evaluation board. The board supports different Upgrade boards. It can be used to test & verify NXP KW45 and NXP K32W14 support.
Minimum requirements
- J-Link software V7.7 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Put a Jumper on J22 to activate the debug interface
- Connect the J-Link to the SWD header (J16)
- Power the board via external power supply (J14)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP KW45B41Z. It is a simple Hello World sample linked into the internal flash.
SETUP
TBD