Difference between revisions of "NXP X-MIMXRT1180-EVK"
(→Preparing for J-Link) |
|||
Line 5: | Line 5: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to J37 |
− | *Power the board via |
+ | *Power the board via J2 (DC 5V) + enable the power switch (SW1) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:NXP_RT1180_CONNECT.PNG|400px]] |
[[File:NXP_RT1180_CONNECT.PNG|400px]] |
Latest revision as of 08:41, 22 September 2023
Contents
This article describes specifics for the NXP X-MIMXRT1180-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J37
- Power the board via J2 (DC 5V) + enable the power switch (SW1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
TBD