Difference between revisions of "Nations N32G030C8L7 STB"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the Nations N32G030C8L7_STB evaluation board. 450px == Minimum requirements == * J-Link software V7.82g or la...")
 
Line 6: Line 6:
   
 
== Minimum requirements ==
 
== Minimum requirements ==
* J-Link software V7.82g or later
+
* J-Link software [comming soon] or later
   
 
== Preparing for J-Link ==
 
== Preparing for J-Link ==
Line 19: Line 19:
 
It is a simple Hello World sample linked into the internal flash.<br>
 
It is a simple Hello World sample linked into the internal flash.<br>
 
====SETUP====
 
====SETUP====
*J-Link software: V7.82g
+
*J-Link software: [comming soon]
 
*Embedded Studio: V6.34
 
*Embedded Studio: V6.34
 
*Hardware: N32G030C8L7_STB
 
*Hardware: N32G030C8L7_STB

Revision as of 16:29, 13 December 2022

This article describes specifics for the Nations N32G030C8L7_STB evaluation board.

450px

Minimum requirements

  • J-Link software [comming soon] or later

Preparing for J-Link

  • Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
  • Power the board via USB (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G030C8L7_STB N32G030C8L7.
It is a simple Hello World sample linked into the internal flash.

SETUP

  • J-Link software: [comming soon]
  • Embedded Studio: V6.34
  • Hardware: N32G030C8L7_STB
  • Link: File:.zip