Difference between revisions of "Nations N32G030C8L7 STB"
Line 1: | Line 1: | ||
− | <!-- |
||
__TOC__ |
__TOC__ |
||
Line 24: | Line 23: | ||
*Hardware: N32G030C8L7_STB |
*Hardware: N32G030C8L7_STB |
||
*Link: [[File:.zip]] |
*Link: [[File:.zip]] |
||
− | --!> |
Revision as of 10:38, 15 February 2023
This article describes specifics for the Nations N32G030C8L7_STB evaluation board.
Minimum requirements
- J-Link software [comming soon] or later
Preparing for J-Link
- Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G030C8L7_STB N32G030C8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: [comming soon]
- Embedded Studio: V6.34
- Hardware: N32G030C8L7_STB
- Link: File:.zip