Difference between revisions of "Nations N32G030C8L7 STB"
(→Example Project) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 15: | Line 16: | ||
[[File:Nations_N32G030C8L7_STB_N32G030C8L7_connect.png|400px]] |
[[File:Nations_N32G030C8L7_STB_N32G030C8L7_connect.png|400px]] |
||
| − | == |
+ | == Example Project== |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G030C8L7_STB N32G030C8L7.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G030C8L7_STB N32G030C8L7.<br> |
||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
Latest revision as of 15:36, 8 May 2024
This article describes specifics for the Nations N32G030C8L7_STB evaluation board.
Minimum requirements
- J-Link software 7.86 or later
Preparing for J-Link
- Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G030C8L7_STB N32G030C8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: 7.86
- Embedded Studio: V6.34
- Hardware: N32G030C8L7_STB
- Link: File:Nations N32G030C8L7 STB N32G030C8L7 TestProject ES V634.zip
