Difference between revisions of "Nations N32G032R8L7 STB"
(Created page with "__TOC__ This article describes specifics for the Mindmotion MB-032 evaluation board. 450px == Minimum requirements == * J-Link software V7.82e...") |
|||
| Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
| − | This article describes specifics for the |
+ | This article describes specifics for the Nations N32G032R8L7_STB evaluation board. |
| − | [[File: |
+ | [[File:Mxxx.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
| − | * J-Link software V7. |
+ | * J-Link software V7.82g or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link : VTref= |
+ | *Connect the J-Link : VTref= J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6 |
| − | *Power the board via USB ( |
+ | *Power the board via USB (J4) |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File: |
+ | [[File:xxx.png|400px]] |
== Example Project== |
== Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G032R8L7_STB N32G032R8L7.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
| − | *J-Link software: V7. |
+ | *J-Link software: V7.82g |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
| − | *Hardware: |
+ | *Hardware: N32G032R8L7_STB |
| − | *Link: [[File: |
+ | *Link: [[File:.zip]] |
Revision as of 15:08, 13 December 2022
This article describes specifics for the Nations N32G032R8L7_STB evaluation board.
Minimum requirements
- J-Link software V7.82g or later
Preparing for J-Link
- Connect the J-Link : VTref= J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G032R8L7_STB N32G032R8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82g
- Embedded Studio: V6.34
- Hardware: N32G032R8L7_STB
- Link: File:.zip
