Difference between revisions of "Nations N32G032R8L7 STB"
Line 3: | Line 3: | ||
This article describes specifics for the Nations N32G032R8L7_STB evaluation board. |
This article describes specifics for the Nations N32G032R8L7_STB evaluation board. |
||
− | [[File: |
+ | [[File:Nations_N32G032R8L7_STB_N32G032R8L7_board.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
− | * J-Link software |
+ | * J-Link software 7.86 or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:Nations_N32G032R8L7_STB_N32G032R8L7_connect.png|400px]] |
== Example Project== |
== Example Project== |
Revision as of 11:05, 15 February 2023
This article describes specifics for the Nations N32G032R8L7_STB evaluation board.
Minimum requirements
- J-Link software 7.86 or later
Preparing for J-Link
- Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G032R8L7_STB N32G032R8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: [comming soon]
- Embedded Studio: V6.34
- Hardware: N32G032R8L7_STB
- Link: File:.zip