Nations N32G032R8L7 STB
Revision as of 15:08, 13 December 2022 by Torben.scharping (talk | contribs)
This article describes specifics for the Nations N32G032R8L7_STB evaluation board.
Minimum requirements
- J-Link software V7.82g or later
Preparing for J-Link
- Connect the J-Link : VTref= J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G032R8L7_STB N32G032R8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82g
- Embedded Studio: V6.34
- Hardware: N32G032R8L7_STB
- Link: File:.zip