Difference between revisions of "Nuvoton-NuMaker-M071MD"
(→Preparing for J-Link) |
|||
| Line 10: | Line 10: | ||
*Power the board via........ |
*Power the board via........ |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| + | [[File:NuMaker-M071MD M071MD2AE Connect.png|400px]] |
||
| − | '''[PICTURE OF CONNECT]''' |
||
== Example Project== |
== Example Project== |
||
Revision as of 19:38, 16 January 2023
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: [[]]
