Difference between revisions of "Nuvoton-NuMaker-M071MD"
(→SETUP) |
|||
| Line 19: | Line 19: | ||
*Embedded Studio: V4.52b |
*Embedded Studio: V4.52b |
||
*Hardware: Nuvoton NuMaker-M071MD |
*Hardware: Nuvoton NuMaker-M071MD |
||
| − | *Link: [[File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip]] |
+ | *Link: [[:File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip]] |
Revision as of 19:48, 16 January 2023
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via J3 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M071MD
- Link: File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip
