Difference between revisions of "Nuvoton NuMaker-M263KI"
(Created page with "__TOC__ This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board. 500px == Minimum requirements == * J-Link sof...") |
|||
| Line 3: | Line 3: | ||
This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board. |
This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board. |
||
| − | [[File: |
+ | [[File:Nuvoton NuMaker-M263KI|500px]] |
== Minimum requirements == |
== Minimum requirements == |
||
Revision as of 18:01, 9 January 2023
This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP2)
- Power the board via USB (GD-LINK CN100)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32A503-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware: GigaDevice GD32A503-EVAL
- Link: File:GigaDevice GD32A503V-EVAL GD32A503VD.zip
