Difference between revisions of "Nuvoton NuMaker-M463KG"
(Created page with "__TOC__ This article describes specifics for the Nuvoton NuMaker-M463KG evaluation board.<br> 600px == Preparing for J-Link == *C...") |
|||
| Line 2: | Line 2: | ||
This article describes specifics for the Nuvoton NuMaker-M463KG evaluation board.<br> |
This article describes specifics for the Nuvoton NuMaker-M463KG evaluation board.<br> |
||
| − | [[File: |
+ | [[File:Nuvoton_NuMaker-M463KG_V1.1_M463KGCAE_connect.png|600px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| Line 17: | Line 17: | ||
*Embedded Studio: V4.52b |
*Embedded Studio: V4.52b |
||
*Hardware: Nuvoton NuMaker-M463KG |
*Hardware: Nuvoton NuMaker-M463KG |
||
| − | *Link: [[:File:Nuvoton_NuMaker- |
+ | *Link: [[:File:Nuvoton_NuMaker-M463KG_V1.1_M463KGCAE_TestProject_ES_V634.zip]] |
Revision as of 12:41, 23 March 2023
This article describes specifics for the Nuvoton NuMaker-M463KG evaluation board.
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
- Power the board via J2 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M463KG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86e
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M463KG
- Link: File:Nuvoton_NuMaker-M463KG_V1.1_M463KGCAE_TestProject_ES_V634.zip
