Difference between revisions of "Nuvoton NuMaker-M463KG"
Line 8: | Line 8: | ||
*Power the board via J2 or ICE J3 |
*Power the board via J2 or ICE J3 |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File:Nuvoton_NuMaker- |
+ | [[File:Nuvoton_NuMaker-M463KG_V1.1_M463KGCAE_connect.png|400px]] |
== Example Project== |
== Example Project== |
Revision as of 12:42, 23 March 2023
This article describes specifics for the Nuvoton NuMaker-M463KG evaluation board.
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
- Power the board via J2 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M463KG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86e
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M463KG
- Link: File:Nuvoton_NuMaker-M463KG_V1.1_M463KGCAE_TestProject_ES_V634.zip