ONSemi RSL15-EVB

This article describes specifics for the ONSemi RSL15-EVB. It can be used to test & verify RSL15 support.

Minimum requirements

• J-Link software V7.82 or later

Preparing for J-Link

Either the built-in J-Link OB or an external J-Link may be used to connect to the target device.

Using J-Link OB

• Power the board via USB-C
• Verify the connection with e.g. J-Link Commander. The output should look as follows:

Using external J-Link

• Connect J-Link to the JTAG/SWD header (J3)
• Power the board via USB-C
• Verify the connection with e.g. J-Link Commander.
  • Now the J-Link OB and the external J-Link are connected to the host. Make sure to select the desired J-Link when prompted.
• The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ONSemi RSL15-EVB V1.1. It is a simple count loop sample linked into the internal flash.

SETUP

• J-Link software: V7.81a
• Embedded Studio: V6.34a
• Hardware: ONSemi RSL15-EVB V1.1
• Link: File:ONSemi RSL15 TestProject ES V634a.zip