Renesas DA1470x DevKit
This article describes specifics for the Renesas DA1470x DevKit evaluation board.
Preparing for J-Link
- Connect the J-Link to the 19-pin debug connector (J31).
- Power the board via USB (J8).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas DA1470x DevKit.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86b
- Embedded Studio: V6.20
- Hardware: Renesas DA1470x DevKit
- Link: File:Renesas DA1470x DevKit TestProject ES V620.zip