Difference between revisions of "Renesas EK-RA2A2"
(→SETUP) |
|||
(2 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 25: | Line 26: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA2A2.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA2A2.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *Embedded Studio: |
+ | *Embedded Studio: V8.10 |
*Hardware: Renesas EK-RA2A2 |
*Hardware: Renesas EK-RA2A2 |
||
− | * |
+ | *[[File:Renesas_R7FA2A2AD_TestProject_ES_V810.zip]] |
Latest revision as of 13:32, 15 May 2024
This article describes specifics for the Renesas EK-RA2A2 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J2 | 1 | VCC |
GND | J2 | 20 | VSS |
TMS/SWDIO | J2 | 18 | P108/SWDIO |
TCK/SWCLK | J2 | 17 | P300/SWCLK |
- Power the board via J10.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA2A2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10
- Hardware: Renesas EK-RA2A2
- File:Renesas R7FA2A2AD TestProject ES V810.zip