Renesas EK-RA4E2
This article describes specifics for the Renesas EK-RA4E2 evaluation board.
Preparing for J-Link
- Connect the J-Link to J13
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA4E2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34
- Hardware: Renesas EK-RA4E2
- Link: File:Renesas EK-RA4E2 TestProject ES V634.zip