Renesas EK-RA6E2

This article describes specifics for the Renesas EK-RA6E2 evaluation board.

Preparing for J-Link

• Connect the J-Link to J13
• Power the board via USB
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6E2.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.86
• Embedded Studio: V6.34
• Hardware: Renesas EK-RA6E2
• Link: File:Renesas EK-RA6E2 TestProject ES V634.zip