Renesas RZ/G2UL SMARC EVK
This article describes specifics for the Renesas RZ/G2UL. A generic startup guide + additional information can be found on Renesas website.
Minimum requirements
- J-Link software V7.84a or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN2) on the SMARC module
- Power the board via CN6 (Power Input)
- Press the POWER button (SW9) in order to supply the SMARC module with power
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas RZ/G2L. It is a simple Hello World sample linked into the internal RAM.
SETUP
- J-Link software: V7.84a
- Embedded Studio: V5.42
- Hardware: Renesas RZ/G2UL EVK (SMARC module)
- Link: File:Renesas RZG2UL RAM TestProject ES V542.zip