Renesas RZ/T2L-RSK

From SEGGER Wiki
Revision as of 10:03, 27 March 2023 by Erik (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Renesas RZ/T2L-RSK evaluation board. 450px == Minimum requirements == * J-Link software V7.8...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Renesas RZ/T2L-RSK evaluation board.

Renesas RZT2L-RSK.jpg

Minimum requirements

  • J-Link software V7.88 or later

Preparing for J-Link

  • Connect the J-Link to the debug header (J13 or J20)
  • Power the board via USB C (CN5) or external power supply / power jack (CN6)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas RZT2M Connect.PNG

NOR flash programming

Not supported yet.

Example Project

TBD

SETUP

TBD

Retrieved from "https://wiki.segger.com/index.php?title=Renesas_RZ/T2L-RSK&oldid=14576"