Renesas RZ/T2L-RSK
Contents
This article describes specifics for the Renesas RZ/T2L-RSK evaluation board.
Minimum requirements
- J-Link software V7.88 or later
Preparing for J-Link
- Connect the J-Link to the debug header (J13 or J20)
- Power the board via USB C (CN5) or external power supply / power jack (CN6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
NOR flash programming
Not supported yet.
Example Project
TBD
SETUP
TBD